点击次数：

所属单位：材料科学工程学院

教研室：材料科学工程学院

发表刊物：Materials Today Communications

项目来源：省、市、自治区科技项目

关键字：Bobbin tool friction stir welding；Copper；Rotation speed；Microstructure；Mechanical properties；Corrosion resistance

摘要：In this study, the effects of different rotation speeds (600, 800, 1000 and 1200 rpm) on the microstructure, mechanical properties, electrochemical corrosion properties and resistivity of T2 pure copper bobbin tool-friction stir welded joint at a fixed welding speed of 50 mm/min were investigated. The results show that the grain size of the microstructure of welded joints with different rotational speeds has a large difference, and the recrystallization mode are continuous dynamic recrystallization, discontinuous dynamic recrystallization and geometric dynamic recrystallization. The fracture location is at the thermo-mechanically affected zone of the retreating side with the largest difference in microstructure gradient and grain size. Due to the combined effect of grain size and low angle grain boundaries distribution, the welded joints at 1000 rpm have higher tensile strength, elongation, microhardness values, and electrical conductivity, and the welded joints at 600 rpm have higher yield strength. The impedance curve and polarization curve fitting results in electrochemical corrosion are consistent, and the corrosion is mainly intergranular corrosion and full-scale corrosion, and has good corrosion resistance at 600 rpm and 1000 rpm rotational speed.

第一作者：宫文彪

论文类型：期刊论文

卷号：35（2023））

页面范围：1

是否译文：否

发表时间：2023-06-03